PHC10-3 PLUS head controller supporting PH10 PLUS (PH10T PLUS, PH10M PLUS or PH10MQ PLUS)

PHC10-3 PLUS head controller receives instructions from the CMM control. The PHC10-3 PLUS controls all head functions and reports system status to the CMM:

  • Drives PH10 PLUS (PH10T PLUS, PH10M PLUS or PH10MQ PLUS) to position - sent either from the HCU1 or CMM.
  • Checks and reports position
  • Flags up errors, e.g. failure to reach position, obstruction before or after locking etc

The PHC10-3 does not process any of the probe sensor signals. These are railed clean through the heads axes and controller to the probe interface.

Compatibility
 
Specifications
 
Length 180 mm
Width 440 mm
Height 44 mm
Weight 1.5 Kg
Data transmission RS232 or USB
Current Consumption
(at 240V)
less than 1 A
PSU electrical ratings
Supply voltage: 100-240 V ± 10%
Frequency range: 50/60 Hz
Power consumption: 49 W max.
Transient voltages: Installation category II
Input connectors 15 way 'D'
Power supply 24 V DC 49 W provided by the Emerson PSU (DP4024N3M) power adaptor
Probe output connectors 7-pin DIN or 9-way 'D' type

Maximum cable length
RS232
USB

 

50 m
5 m (extendible in lengths of 5 m by use of a hub, to a maximum length of 30 m)

Hand held control unit HCU1 only